On entry: ifail must be set to , or to set behaviour on detection of an error; these values have no effect when no error is detected.
A value of causes the printing of an error message and program execution will be halted; otherwise program execution continues. A value of means that an error message is printed while a value of means that it is not.
If halting is not appropriate, the value or is recommended. If message printing is undesirable, then the value is recommended. Otherwise, the value is recommended. When the value or is used it is essential to test the value of ifail on exit.
On exit: unless the routine detects an error or a warning has been flagged (see Section 6).
6Error Indicators and Warnings
If on entry or , explanatory error messages are output on the current error message unit (as defined by x04aaf).
Errors or warnings detected by the routine:
On entry, . The function returns zero. Constraint: . x is too large, the result underflows and the function returns zero.
On entry, . Constraint: . The function is undefined and returns zero.
An unexpected error has been triggered by this routine. Please
See Section 7 in the Introduction to the NAG Library FL Interface for further information.
Your licence key may have expired or may not have been installed correctly.
See Section 8 in the Introduction to the NAG Library FL Interface for further information.
Dynamic memory allocation failed.
See Section 9 in the Introduction to the NAG Library FL Interface for further information.
Let be the absolute error in the result, and be the relative error in the argument. If is somewhat larger than the machine representation error, then we have:
For small , errors are attenuated by the function and hence are limited by the machine precision.
For medium and large , the error behaviour, like the function itself, is oscillatory and hence only absolute accuracy of the function can be maintained. For this range of , the amplitude of the absolute error decays like , which implies a strong attenuation of error. Eventually, , which is asymptotically given by ,becomes so small that it cannot be calculated without causing underflow and, therefore, the routine returns zero. Note that for large , the errors are dominated by those of the standard function exp.
8Parallelism and Performance
Background information to multithreading can be found in the Multithreading documentation.
s19adf is not threaded in any implementation.
Underflow may occur for a few values of close to the zeros of , below the limit which causes a failure with .
This example reads values of the argument from a file, evaluates the function at each value of and prints the results.