NAG Library Manual, Mark 28.7
Interfaces:  FL   CL   CPP   AD 

NAG FL Interface Introduction
Example description

 D03PLF Example Program Results


 Example 1


 Method Parameters:
  Number of mesh points used =  201
  Relative tolerance used    =  0.250E-03
  Absolute tolerance used    =  0.100E-04

 Integration Results:
  Global error is less than 100 times the local error tolerance.


 Example 2


 Problem Parameter and initial conditions:
  gamma          = 1.400
      e(x<0.5,0) = 2.500    e(x>0.5,0) = 0.250
    rho(x>0.5,0) = 1.000  rho(x>0.5,0) = 0.125

 Method Parameters:
  Number of mesh points used =  141
  Relative tolerance used    =  0.500E-03
  Absolute tolerance used    =  0.500E-02

 Solution
    t      x     density velocity pressure
  0.100  0.0000   1.0000   0.0000   1.0000
          0.100   1.0000  -0.0000   1.0000
          0.200   1.0000  -0.0000   1.0000
          0.300   1.0000  -0.0000   1.0000
          0.400   0.8668   0.1665   0.8188
          0.500   0.4299   0.9182   0.3071
          0.600   0.2969   0.9274   0.3028
          0.700   0.1250   0.0000   0.1000
          0.800   0.1250  -0.0000   0.1000
          0.900   0.1250  -0.0000   0.1000
          1.000   0.1250   0.0000   0.1000

  0.200  0.0000   1.0000   0.0000   1.0000
          0.100   1.0000  -0.0000   1.0000
          0.200   1.0000  -0.0000   1.0000
          0.300   0.8718   0.1601   0.8253
          0.400   0.6113   0.5543   0.5022
          0.500   0.4245   0.9314   0.3014
          0.600   0.4259   0.9277   0.3030
          0.700   0.2772   0.9272   0.3031
          0.800   0.2657   0.9276   0.3032
          0.900   0.1250  -0.0000   0.1000
          1.000   0.1250   0.0000   0.1000