The routine may be called by the names s20aqf or nagf_specfun_fresnel_s_vector.
s20aqf evaluates an approximation to the Fresnel integral
for an array of arguments , for .
Note: , so the approximation need only consider .
The routine is based on three Chebyshev expansions:
For small , . This approximation is used when is sufficiently small for the result to be correct to machine precision. For very small , this approximation would underflow; the result is then set exactly to zero.
For large , and . Therefore, for moderately large , when is negligible compared with , the second term in the approximation for may be dropped. For very large , when becomes negligible, . However, there will be considerable difficulties in calculating accurately before this final limiting value can be used. Since is periodic, its value is essentially determined by the fractional part of . If where is an integer and , then depends on and on modulo . By exploiting this fact, it is possible to retain significance in the calculation of either all the way to the very large limit, or at least until the integer part of is equal to the maximum integer allowed on the machine.
On entry: ifail must be set to , or to set behaviour on detection of an error; these values have no effect when no error is detected.
A value of causes the printing of an error message and program execution will be halted; otherwise program execution continues. A value of means that an error message is printed while a value of means that it is not.
If halting is not appropriate, the value or is recommended. If message printing is undesirable, then the value is recommended. Otherwise, the value is recommended. When the value or is used it is essential to test the value of ifail on exit.
On exit: unless the routine detects an error or a warning has been flagged (see Section 6).
6Error Indicators and Warnings
If on entry or , explanatory error messages are output on the current error message unit (as defined by x04aaf).
Errors or warnings detected by the routine:
On entry, .
An unexpected error has been triggered by this routine. Please
See Section 7 in the Introduction to the NAG Library FL Interface for further information.
Your licence key may have expired or may not have been installed correctly.
See Section 8 in the Introduction to the NAG Library FL Interface for further information.
Dynamic memory allocation failed.
See Section 9 in the Introduction to the NAG Library FL Interface for further information.
Let and be the relative errors in the argument and result respectively.
If is somewhat larger than the machine precision (i.e., if is due to data errors etc.), then and are approximately related by:
Figure 1 shows the behaviour of the error amplification factor
However, if is of the same order as the machine precision, then rounding errors could make slightly larger than the above relation predicts.
For small , and hence there is only moderate amplification of relative error. Of course for very small where the correct result would underflow and exact zero is returned, relative error-control is lost.
For moderately large values of ,
and the result will be subject to increasingly large amplification of errors. However, the above relation breaks down for large values of (i.e., when is of the order of the machine precision); in this region the relative error in the result is essentially bounded by .
Hence the effects of error amplification are limited and at worst the relative error loss should not exceed half the possible number of significant figures.
8Parallelism and Performance
Background information to multithreading can be found in the Multithreading documentation.
s20aqf is not threaded in any implementation.
This example reads values of x from a file, evaluates the function at each value of and prints the results.