NAG Library Routine Document
S17ASF returns an array of values of the Bessel function .
||N, IVALID(N), IFAIL
S17ASF evaluates an approximation to the Bessel function of the first kind for an array of arguments , for .
Note: , so the approximation need only consider .
The routine is based on three Chebyshev expansions:
For near zero, . This approximation is used when is sufficiently small for the result to be correct to machine precision.
For very large
, it becomes impossible to provide results with any reasonable accuracy (see Section 7
), hence the routine fails. Such arguments contain insufficient information to determine the phase of oscillation of
; only the amplitude,
, can be determined and this is returned on soft failure. The range for which this occurs is roughly related to machine precision
; the routine will fail if
(see the Users' Note
for your implementation for details).
Abramowitz M and Stegun I A (1972) Handbook of Mathematical Functions (3rd Edition) Dover Publications
Clenshaw C W (1962) Chebyshev Series for Mathematical Functions Mathematical tables HMSO
- 1: N – INTEGERInput
On entry: , the number of points.
- 2: X(N) – REAL (KIND=nag_wp) arrayInput
On entry: the argument of the function, for .
- 3: F(N) – REAL (KIND=nag_wp) arrayOutput
On exit: , the function values.
- 4: IVALID(N) – INTEGER arrayOutput
contains the error code for
- No error.
|On entry,|| is too large. contains the amplitude of the oscillation, .|
- 5: IFAIL – INTEGERInput/Output
must be set to
. If you are unfamiliar with this parameter you should refer to Section 3.3
in the Essential Introduction for details.
For environments where it might be inappropriate to halt program execution when an error is detected, the value
is recommended. If the output of error messages is undesirable, then the value
is recommended. Otherwise, if you are not familiar with this parameter, the recommended value is
. When the value is used it is essential to test the value of IFAIL on exit.
unless the routine detects an error or a warning has been flagged (see Section 6
6 Error Indicators and Warnings
If on entry
, explanatory error messages are output on the current error message unit (as defined by X04AAF
Errors or warnings detected by the routine:
On entry, at least one value of X
for more information.
On entry, .
Let be the relative error in the argument and be the absolute error in the result. (Since oscillates about zero, absolute error and not relative error is significant.)
is somewhat larger than the machine precision
is due to data errors etc.), then
are approximately related by:
is also within machine bounds). Figure 1
displays the behaviour of the amplification factor
However, if is of the same order as machine precision, then rounding errors could make slightly larger than the above relation predicts.
For very large , the above relation ceases to apply. In this region, . The amplitude can be calculated with reasonable accuracy for all , but cannot. If is written as where is an integer and , then is determined by only. If , cannot be determined with any accuracy at all. Thus if is greater than, or of the order of, the inverse of the machine precision, it is impossible to calculate the phase of and the routine must fail.
This example reads values of X
from a file, evaluates the function at each value of
and prints the results.
9.1 Program Text
Program Text (s17asfe.f90)
9.2 Program Data
Program Data (s17asfe.d)
9.3 Program Results
Program Results (s17asfe.r)