NAG fl90, Release 4


NEC SX-5 64-bit Single Precision (IEEE Format)

Installer's Note


1. Introduction

This document is essential reading for whoever is responsible for the installation of the NAG fl90 implementation specified in the title. The installer will be supplied with a printed copy of this document. Both this (doc/in.html) and the Users' Note (doc/un.html) are supplied on the distribution medium.

Whenever the NAG fl90 has been supplied in compiled form, that form is considered to be the standard library file. The use of all supplied software must be in accordance with the terms and conditions of the Software Licence signed by NAG and each site. Any request to use NAG software on a computer other than the one licensed must be referred to NAG (see Section 6).

2. Implementation Provided

2.1. Applicability

This implementation is a compiled, tested, ready-to-use version of NAG fl90 that is considered suitable for operation on the computer systems detailed below:
hardware:           all NEC SX-5 systems
operating system:   SUPER-UX 11.1 or greater
Fortran compiler:   F90/SX Rev 231 or compatible
For information about implementations of NAG fl90 for use on other computer systems please contact NAG.

2.2. Derivation

This implementation was produced at NEC Systems Inc, The Woodlands (Texas) on the computing system detailed below:
hardware:           SX-5/8
operating system:   SUPER-UX 11.1
Fortran compiler:   F90/SX Rev 231 
compiler options:   -P stack -Cvopt -Wf,-w,double16,-pvctl,noassume,vwork=stack
The entire NAG fl90 library, Release 4, was compiled with the above options (that is, with default optimization), with the exception of the following underlying procedures, which were compiled unoptimized...

    with options -Cvsafe -Wf,-w,double16,-pvctl,noassume,vwork=stack :
     c02agy_7s     c06rpf_9s     f04bff_9s     g13ezf_9s
     c06fpf_9s     c06rqf_9s     f07bax_9s
     c06fqf_9s     f02tef_9s     g13ebf_9s
    with options -Cdebug -Wf,-w,double16 :
     f07tff_9s     f07ttf_9s     f07uff_9s

3. Distribution Medium

3.1. Recording Details

The implementation is distributed in tar format on CD-ROM, unless otherwise indicated on the medium and accompanying despatch note.

For further details, refer to other documentation supplied or contact NAG (see Section 6).

3.2. Contents

The following shows the directory/file organization of the library materials as they will be installed.
                      |-- in.html
            |-- doc --|-- un.html
            |         |-- nag_fn_un.3
            |-- libnagfl90.a 
            |-- libnagfl90_noblas.a
            |-- nag_mod_dir --|-- *.mod
fnne504sa --|
            |              |-- source ---|-- *.f90
            |-- examples --|-- data -----|-- *.dat
            |              |-- results --|-- *.r
            |-- scripts ---|-- nagexample
libnagfl90.a is the compiled library including the NAG version of the BLAS procedures while libnagfl90_noblas.a does not contain the NAG version of the BLAS procedures and MUST be used with the vendor tuned BLAS contained in the NEC Mathkeisan product.

The following shows the directory/file organization of the PDF documentation materials as they will be installed.

         |-- images --|-- *.gif
         |                   |-- release4.html  (main index)
         |                   |
         |                   |-- genint --|-- *.html  (introductory material)
NAGdoc --|        |-- html --|
         |        |          |-- library_contents --|-- *.html
         |        |          |
         |        |          |-- [c01-c29]_fn04.html  (chapter indexes)
         |-- fn --|
                  |         |-- genint --|-- *.pdf  (introductory material)
                  |         |
                  |         |-- library_contents --|-- *.pdf
                  |-- pdf --|
                            |-- indexes --|-- *.pdf  (KWIC and GAMS)
                            |-- [c01-c29] --|-- *.pdf  (chapter and function

3.3. File Sizes

The files require approximately the following disk space:
compiled library:                    25.7 Mb
compiled library (without NAG BLAS): 25.0 Mb
module information files:            15.6 Mb
example program material:             5.9 Mb
library documentation files:         40.0 kb
PDF documentation files:             21.0 Mb

4. Installation

4.1. Library Installation

To install all library material use the Unix tar utility, e.g.
tar xvf /cdrom/fn04.tar
(assuming the CD-ROM has been mounted as /cdrom).

Two object libraries (libnagfl90.a and libnagfl90_noblas.a) are provided to enable usage on all NEC SX-5 systems however only one of them should be made available at each site. The NEC Mathkeisan product contains components that improve the run-time performance of NAG Library procedures consequently if this is licensed then libnagfl90_noblas.a should be made available; otherwise libnagfl90.a should be made available. To make the appropriate library available it should be moved to a directory, such as /usr/lib, in the default search path of the linker, if possible, so that linkage is convenient.

The module information files (nag_mod_dir/*.mod) are supplied in pre-compiled module form. They should be moved to a suitable location so that access is convenient, e.g.

mkdir /usr/local/lib/fl90_modules
mv nag_mod_dir/* /usr/local/lib/fl90_modules
The -I"pathname" option should then be specified on each f90 invocation (where "pathname" is /usr/local/lib/fl90_modules) to tell the compiler where to find the modules.

Alternatively, the files may be moved to the same directory as the pre-defined modules supplied with the compiler.

The script nagexample refers to the local directory containing the example programs. The script must be modified to reflect the file locations in the local installation. The script also assumes that libnagfl90.a is being used; if libnagfl90_noblas.a is actually made available the script should be modified, as indicated in comments, to reflect this. The file should then be copied to (for example) /usr/local/bin and its protection set to world execute.

The man page, which directs users to the HTML form of the Users' Note, should be moved to a directory in the man search path, e.g.

cd doc
mv nag_fn_un.3 /usr/man/C

4.2. PDF Documentation Installation

To install all PDF documentation material, use the Unix tar utility, e.g.
tar xvf /cdrom/pdf.tar
(assuming the CD-ROM has been mounted as /cdrom).

You may wish to move the PDF documentation files to the same location as that for other NAG products.

4.3. Checking Accessibility

The installer should ensure that the advice given to users in Section 3.1 of the Users' Note (doc/un.html) is suitable for the installation. This can be done by running a few example programs following that advice. The installation can also be tested using the script nagexample.

The examples results given in the directory results are those obtained using libnagfl90.a. Using libnagfl90_noblas.a and the NEC tuned BLAS may produce slightly different results.

4.4. Release to Users

The Users' Note (doc/un.html) should be checked and amended as necessary (particularly Section 3.1 which will require modification to reflect which libraries are made available). It can then be made available to users directly, or be absorbed into local access information.

The following material should also be made accessible to users:

compiled library:

libnagfl90.a or libnagfl90_noblas.a
modules information files:
example program material:
pdf documentation files

Note that the example material has been adapted, if necessary, from that printed in the NAG fl90 Manual, so that programs are suitable for execution with this implementation with no further changes. Making the example material directly available to users provides them with easily adaptable templates for their own problems.

4.5. Maintenance Level

The maintenance level of the library can be determined by writing a simple program to call procedure nag_lib_ident, which prints out details of the implementation, including title and product code, compiler and precision used, release and maintenance level.

5. Documentation

Each supported NAG fl90 site is currently provided with a printed copy of the NAG fl90 Manual (or Update). Additional copies are available for purchase; please refer to the NAG documentation order form (available on the NAG websites, see Section 6 (c)) for details of current prices.

On-line documentation is provided, in PDF form, with this implementation. Please see the Readme file on the distribution medium for further information.

6. Support from NAG

(a) Contact with NAG

Queries concerning this document or the implementation generally should be directed initially to your local Advisory Service. If you have difficulty in making contact locally, you can contact NAG directly at one of the addresses given in the Appendix. Users subscribing to the support service are encouraged to contact one of the NAG Response Centres (see below).

(b) NAG Response Centres

The NAG Response Centres are available for general enquiries from all users and also for technical queries from sites with an annually licensed product or support service.

The Response Centres are open during office hours, but contact is possible by fax, email and phone (answering machine) at all times.

When contacting a Response Centre please quote your NAG site reference and NAG product code (FNNE504SA).

(c) NAG Websites

The NAG websites are an information service providing items of interest to users and prospective users of NAG products and services. The information is reviewed and updated regularly and includes implementation availability, descriptions of products, downloadable software, product documentation and technical reports. The NAG websites can be accessed at

or (in North America)

or (in Japan)

(d) NAG Electronic Newsletter

If you would like to be kept up to date with news from NAG you may want to register to receive our electronic newsletter, which will alert you to special offers, announcements about new products or product/service enhancements, case studies and NAG's event diary. To register visit one of our websites or contact us at

7. User Feedback

Many factors influence the way NAG's products and services evolve and your ideas are invaluable in helping us to ensure that we meet your needs. If you would like to contribute to this process we would be pleased to receive your comments by email at Alternatively contact the appropriate NAG Response Centre who will be happy to record your comments.

Appendix - Contact Addresses

Wilkinson House
Jordan Hill Road
OXFORD  OX2 8DR                         NAG Ltd Response Centre
United Kingdom                          email:

Tel: +44 (0)1865 511245                 Tel: +44 (0)1865 311744
Fax: +44 (0)1865 310139                 Fax: +44 (0)1865 310139

1431 Opus Place, Suite 220
Downers Grove
IL 60515-1362                           NAG Inc Response Center
USA                                     email:

Tel: +1 630 971 2337                    Tel: +1 630 971 2345
Fax: +1 630 971 2706                    Fax: +1 630 971 2706

Nihon NAG KK
Hatchobori Frontier Building 2F

Tel: +81 (0)3 5542 6311
Fax: +81 (0)3 5542 6312